SeaDoo GTX DI Operations Instructions download pdf (Page 18)

16

At this point, install a hose pincher on

bleed outlet hose.

1. Bleed outlet hose

Continue to pour until antifreeze flows

in air compressor water outlet hose.

1. Air compressor water outlet hose

Remove pinchers in this order to allow

proper flow of antifreeze.

1. Bleed outlet hose.

2. Crankcase cooling cover outlet hose.

3. Engine cylinder drain hose.

4. Water outlet hose.

Pour approximately 200 mL (7 oz) of

antifreeze in the water regulator valve

supply hose to allow antifreeze flow-

ing through the valve and into muffler

to protect it.

Remove temporary hose and recon-

nect engine water outlet hose.

Most of the antifreeze will drain out

when removing the hose pinchers. Use

a container to recover it. DISPOSE AN-

TIFREEZE AS PER YOUR LOCAL LAWS

AND REGULATIONS.

NOTE: Although antifreeze will mainly

drain out, the antifreeze has mixed with

the water that was possibly trapped in

the water jackets and thus preventing

freezing problems.

At pre-season preparation, drain the

remaining antifreeze from cooling sys-

tem prior to using the watercraft.

The following steps should be per-

formed to provide the watercraft en-

hanced protection.

Clean the bilge with hot water and de-

tergent or with bilge cleaner. Rinse

thoroughly. Lift front end of watercraft

to completely drain bilge. If any repairs

are needed to body or to the hull con-

tact your authorized SEA-DOO dealer.

For paint touch up to mechanical parts

use Bombardier spray paint.

Reinstall vent tube support.

F18E0EY

1

1

F18E01Y

smo2002-005a.book Page 16 Friday, September 7, 2001 11:34 AM

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments